When should I use this guide?
Use this guide when you want to connect machines from Dynapac's Dynalink telematics portal directly to Infobric Machines through AEMP without installing a separate telematics device.
In Infobric Machines, the provider is shown as Dynalink. The integration can be configured directly when the provider has the status Inactive.
When the integration is complete, the machines are normally created in Infobric Machines within one hour.
Prerequisites
You need:
access to Infobric Machines on the web
the Owner or Administrator role
access to the relevant machines in Dynalink
the Client ID and Client secret for the Dynalink AEMP 2.0 API
Contact Dynapac or your Dynapac dealer if you do not have the required credentials.
Connect Dynalink
Sign in to Infobric Machines.
Open Telematics.
Select Integrate machines.
Open Machine connections.
Search for Dynalink or select the provider under Inactive.
Enter the Client ID and Client secret under Enter authentication.
If you need another set of credentials, select Add another authentication.
Select Connect and collect data.
Continue through Collect data and Complete the integration.
When the connection is complete, Infobric Machines starts collecting the machine data made available by Dynalink. New machines are normally created within one hour.
Which Dynalink data is displayed?
Infobric Machines can display the following data when it is supplied by Dynalink:
machine identification and basic machine information
hour meter
position
engine on or off
fuel used
fuel level
idle hours
Availability depends on the machine, its equipment and the data recorded by Dynalink.
Dynalink supplies snapshot data only. This means that Infobric Machines collects the latest available value but does not receive a complete history from the provider.
As a result:
data from before the connection is not collected
data from a temporary interruption is not recovered
short engine runs between data collections can be missed
the position represents a current point, not a complete route trail
If it does not work
Check that:
you selected Dynalink
the Client ID and Client secret are for the Dynalink AEMP 2.0 API
the credentials have access to the machines you want to connect
all required fields are complete
The Connect and collect data button is not available until all required information has been entered.
If no machines or data appear after the connection, wait up to one hour and try again. If the problem remains, first verify the machines and API access in Dynalink, then contact support.
Infobric Machines displays the information received from Dynalink. Missing or incorrect source data must be checked with Dynapac or your dealer.
Tips
Confirm that AEMP access is active in Dynalink before you begin.
Use Add another authentication if your machines are split across several Dynalink accounts.
Remember that snapshot data does not provide the same history as an integration with time-series data.
Learn more at Dynalink.
Never include real credentials in screenshots or support messages.